https://learningnetwork.cisco.com/thread/81423
Hi Conwyn,
Thanks for the response.
From which prompt would we enable the encryption type? This is not been listed on any of the prompts for the autonomous AP that is with me.
ap(config)#dot11 ssid guest1
ap(config-ssid)#vlan 44
ap(config-ssid)#authen
ap(config-ssid)#authentication ke
ap(config-ssid)#authentication ?
client EAP client information
key-management key management
network-eap leap method
open open method
shared shared method
ap(config-ssid)#authentication open
ap(config-ssid)#authentication key-management wpa version 2
ap(config-ssid)#mbssid guest-mode
ap(config-ssid)#wpa-psk ascii ?
0 Specifies an UNENCRYPTED key will follow
7 Specifies a HIDDEN key will follow
LINE Clear WPA password
ap(config-ssid)#wpa-psk ascii 0 1234567890
ap(config)#dot11 ssid guest1
ap(config-ssid)#encr
ap(config-ssid)#?
ssid configuration commands:
11w-pmf 11w PMF Client Configuration
accounting radius accounting
authentication authentication method
band-select enable band select
dot1x SSID Config Commands for IEEE 802.1X
exit Exit from ssid sub mode
guest-mode guest ssid
ids IDS MFP Client Configuration
information-element Add information element
infrastructure-ssid ssid used to associate to other infrastructure devices
ip IP options
max-associations set maximum associations for ssid
mbssid Multiple BSSID
mobility enable L3 mobility
no Negate a command or set its defaults
rate_limit Dot11 Rate_Limitr Configuration Options
vlan bind ssid to vlan
web-auth Web Authentication
wpa-psk Configure Wi-Fi Protected Access pre-shared key
xconnect tunnel incoming frames
ap(config-ssid)#end
沒有留言:
張貼留言
注意：只有此網誌的成員可以留言。